Chapter Check · Electric Current, Drift Velocity and Ohm's Law

Question 1Application

1. A resistor's resistance is found to increase noticeably as more current is passed through it, due to self-heating. Strictly speaking, over this range of increasing current, is the resistor's V-I behavior perfectly ohmic?

A Yes, as long as V and I are both positiveB Cannot be determined without knowing the exact resistance valuesC No — R must stay constant for the behavior to be strictly ohmic, and here it's changing due to heatingD Yes, since V=IR can still be computed at each point

Question 2Challenge

2. A wire carries a current that grows linearly with time: I(t)=2t (in amperes, t in seconds), starting from t=0. Find the total charge that flows between t=0 and t=5 s.

A 50 CB 5 CC 25 CD 10 C

Question 3Challenge

3. A wire tapers uniformly so that its cross-sectional area varies with position x as A(x)=A₀(1+x) (x in metres, A₀=2×10⁻⁶ m²), carrying a steady current of 8 A. Find the current density at x=0 and at x=3 m.

A J(0)=1×10⁶ A/m², J(3)=4×10⁶ A/m²B J(0)=4×10⁶ A/m², J(3)=4×10⁶ A/m² (unchanged)C J(0)=8×10⁶ A/m², J(3)=2×10⁶ A/m²D J(0)=4×10⁶ A/m², J(3)=1×10⁶ A/m²

Question 4Foundation

4. A charge of 104 C flows through a wire in 8 seconds. Find the current.

A 13 AB 0.077 AC 832 AD 96 A

Question 5Application

5. Two wires, X and Y, made of the same metal (same n) carry the same current, but wire X has twice the cross-sectional area of wire Y. Compare their drift velocities.

A Drift velocity in X is half that in YB Drift velocity in X is double that in YC They are equalD Cannot be determined without more information

Question 6Application

6. How many electrons flow past a cross-section per second in a wire carrying exactly 3.2 A? Use e=1.6×10⁻¹⁹ C.

A 6.25×10¹⁸ electrons/sB 3.2×10⁻¹⁹ electrons/sC 2×10¹⁸ electrons/sD 2×10¹⁹ electrons/s

Question 7Foundation

7. A wire has n=1×10²⁸ per m³, A=4×10⁻⁶ m², carrying a current of 3.2 A. Find the drift velocity. Use e=1.6×10⁻¹⁹ C.

A 5×10⁻⁵ m/sB 5×10⁻⁴ m/sC 1×10⁻⁴ m/sD 2.5×10⁻⁴ m/s

Question 8Application

8. Inside a battery's external circuit, electrons flow from the negative terminal, through the wire, to the positive terminal. In which direction is conventional current considered to flow through this EXTERNAL circuit?

A From the negative terminal to the positive terminal, matching electron flowB There is no conventional current in this caseC Conventional current only exists inside the batteryD From the positive terminal, through the wire, to the negative terminal

Question 9Foundation

9. A resistor of 13 Ω carries a current of 3 A. Find the voltage across it.

A 16 VB 4.33 VC 10 VD 39 V

Question 10Foundation

10. A conductor draws 3 A at 33 V, and 7 A at 77 V. Verify Ohm's Law and find R.

A Ohmic, R=11 ΩB Non-ohmicC Ohmic, R=7 ΩD Ohmic, R=22 Ω

Question 11Challenge

11. A current of 5 A flows through a wire for 2 minutes, then increases to 8 A for the next 3 minutes. Find the total charge that has flowed.

A 600 CB 1040 CC 2040 CD 1440 C

Question 12Challenge

12. A wire's free electron density is 5×10²⁸ per m³ and its cross-sectional area is 2.5×10⁻⁶ m². If the drift velocity is measured to be 4×10⁻⁴ m/s, find the current flowing, then find how many electrons pass a given cross-section every second. Use e=1.6×10⁻¹⁹ C.

A I=8 A, 1.25×10¹⁹ electrons/sB I=1.25×10²³ A, 5×10¹⁹ electrons/sC I=8 A, 8×10¹⁹ electrons/sD I=8 A, 5×10¹⁹ electrons/s

Question 13Application

13. A single wire carries the same current through a wide section (A=18×10⁻⁶ m²) and a narrow section (A=2×10⁻⁶ m²). Find the ratio v_d(narrow)/v_d(wide).

A 18B 9C 1/9D 4.5

Question 14Challenge

14. A component's resistance R(T) increases with temperature: at 20°C, R=8 Ω; at 70°C, R=13 Ω. If it carries exactly 2 A at 70°C, find the voltage across it at that temperature, and state whether the device behaves as strictly ohmic across this temperature range.

A 13 V; not ohmicB 26 V; not strictly ohmic across this temperature range, since R itself changesC 16 V; ohmic across the rangeD 26 V; ohmic across the range, since V=IR was still used correctly

Question 15Foundation

15. A wire of cross-sectional area 4×10⁻⁶ m² carries a current of 20 A. Find the current density.

A 1×10⁷ A/m²B 5×10⁵ A/m²C 5×10⁶ A/m²D 2.5×10⁶ A/m²

Check the complete chapter.

Concept-band performance

Difficulty performance